There are three ways to set up lots. i.e multipler, natural , fibpnacci. 
The lot reversion method should always be applied to the above three methods.

Do you understand the lot reversal method?
If SL is closed, the lot of the next order is increased.
***************************************************
1. If the multiplier method is set and multiplier=2,
Lot 1, 2, 4, 8,... At this time, if the order of 8 lots is closed at TP, the lot of the next order by ma ? or must be 4 lots.

2. If the lot setting method was Fibonacci, 1,1,2,3,5,... If the order of 5 lots was closed at TP, the lot of the next order should be 3 lots.

3. If it was a natural increase method, 1, 3, 5, 7, 9,... Similarly, if 9 lots were closed at TP, the lot for the next order should be 7 lots.

Users can select one of three lot setting options. The lot reversion method must be applied to each method.




<Explanation of logic>

Logic 1 is the trend logic,
All orders always start from logic 1.
When the order of logic 1 is closed at TP, the order in the same direction is repeated with the same number of lots.
If logic 1 is closed by SL, the logic changes to 2.

(Important) When the logic changes, it starts with an order in the same direction as the previous order.

For example, if the lot setting method is set to multiplier = 2,

If the buy 1.0 order by logic 1 is closed by SL, it must be changed to logic 2 and an order of buy 2.0 must be placed at the same time.

Also, if the order for logic 2 of buy 2.0 is also closed by SL, it must be changed back to logic 1 and at the same time an order for buy 4.0 must be placed.

If buy 4.0's order is closed at TP here, #1
Or here, if the buy 4.0 order is closed in SL, #2

In case #1, the logic is maintained as number 1, and the number of lots is 2.0, which was the number of leading lots of 4 lots, depending on the retracement method. Therefore, the buy 2.0 order must be executed.

In case #2, the logic changes to number 2, and since the number of lots was multiplier = 2, the order should be buy 8.0.

In case #2,
If buy8.0's order is closed at TP, #3
Or here, if the buy 8.0 order is closed in SL, #4

In case #3, the logic remains at number 2, and the number of lots becomes 4 according to the reversal method. Therefore, logic number 2 is a sideways trading logic and since sell and buy intersect, in this case it should be a sell 4.0 order.
(In addition, if the sell 4.0 order is closed at TP, the next order must be a buy 2.0 order.)

In case #4, the logic changes to number 1, and the buy 16.0 order must be executed.


MA is only used when starting the first order.
And it is only used when setting up automatic ordering.
It is used only to determine sell and buy for the first order.

Other than that, there is no need to use the MA value at all.