Initial trade setup (update 2.0)

The complete system should no longer start using an indicator, but predefined by the start time in X min
where buy or sell should be activated
or alternate buy and sell

example
Trade start time 240min = X in min (in M1 chart) This means a trade in buy or sell should be opened every 240 min (only if no trade is active via the magic number.)

Initial trade direction buy or sell or alternate between buy and sell.

Important Start time must be able to be optimized via back tests
Initial trade direction too
after Start-Trade> Gridsystem> Recovery-Zone> dismantling system


-------------------------------------------------- -------------------------------------------------- -------------------------------------------------- ---
Grid system (Update2.0)

Trade positions on one side only
Example if the start position is opened in Buy and the price falls
open the next buy position at -200 points

important the following parameters must be configurable

Number of one-sided grid 2
Distance in points Example 200 (distance between the
                                                         unilateral position
Grid Martingale 2.0 [degree of increase in
                                                               Solder numbers)

koefGridDist points + 2.0 (degree of increase of each
                                                                Positions
koefGridDist points -2.0 (degree of reduction negative koefGridDist of the individual positions between the first trade and the following positions.


important only one-sided buy-grid trade or sell-grid trade but not both.

All parameters must be configurable via backtest

-------------------------------------------------- -------------------------------------------------- ------------
-------------------------------------------------- -------------------------------------------------- -----------


Recovery Zone (update 2.0)



Insert update 2.0 (koefGridDist points)

koefGridDist points

 +2.0 (degree of increase of each
          Grid zone distances depending on (HedgeMartDistPiont)

-2.0 Reduction of the individual grid zone distances

(Degree of reduction of the individual grid zone distances depending on (HedgeMartDistPiont)

All parameters must be configurable via backtest